Transformers G1 Cyclonus 3D Printed Replacement Gun G1 Cyclonus is NOT INCLUDED and is for display purposes only. This is a good quantity part made by me. This is 3D printed and NOT THE ORIGINAL. I scanned this from my original, then edited it to make the print stronger, so there are some very minor differences, for the better. Supports had to be used, so there may be some rough edges on the back of scope, gun but, and magazine as shown in pictures. I may clean these up a bit, but you could use 3000 grit sand paper if it is not enough for your liking. This is a 3D printed reproduction gun, perfect for collectors and fans of the franchise. The gun is silver color and is made of full infill PLA. Please note that the gun is not the original one. But you can complete your figure at a much lower cost with a good quality replacement. Please ask any questions before buying.