SDI CS42 PROBE conductivity SENSOR TEMP K=0.01 10K TC (01/03) 9" L NEW $149 Conductivity Properly understood and applied, conductivity is probably simpler to operate and maintain than any other analytical measurement. Each type of sensor has certain applications for which it is best suited. Most applications decisions involve the sensor more than the instrument. Modern instruments are so featured-packed that they will cover almost any application, but not so the sensors. They are where the measurement system meets the process. Measure conductivity directly in process temperatures up to 150ºC @ 100 PSIG O-ring seals used on all versions for high on-stream reliability Optional wet-tap valve allows insertion and removal with line under pressure The CS40 and CS42 sensors have been designed for a wide measurement range in difficult process conditions. It can be installed in submersion, insertion, or wet-tap configurations, and is good for most applications from high purity water to high chemical concentrations. Application Notes Wetted materials of construction are 316 stainless steel and PEEK, with alternate materials available on request. All possible leak paths through the sensor are double sealed with EPDM O-rings for maximum on-stream reliability. The front O-rings isolate the back ones from chemical attack, giving more than double the service life that can be expected from single sealed units. Process connections are made via a bored through swage fitting with 3/4? NPT threads. This fitting can be screwed into a line, a tank, or the optional wet-tap valve assembly. It can also be turned around and connected to a standpipe for use in a submersion configuration. Available cell constants range from 0.01 to 20.0 giving it a very broad scope of application. SPECIFICATIONS MAX. PRESSURE/TEMP. RATINGS: 100 PSIG at 150ºC Valve Assembly ? 50 PSIG at all temperatures, no exceptions. WETTED MATERIALS: Insulator ? PEEK O-Rings ? EPDM FDA APPROVED Electrodes ? 316 Stainless Steel CONNECTIONS: Process ? 3/4? NPT, 1? NPT for valve Electrical ? 3/4? FNPT conduit hub; terminal strip to accept stripped leads, 14-24 ga. CELL CONSTANTS: 20 / 10 / 5 / 2 / 1 / 0.2 / 0.1 / 0.05 / 0.02 / 0.01 Ventureflorida is an asset recovery wholesaler specializing in new and used surplus industrial equipment. We are not a representative of any manufacturer listed; all names, logos, descriptions and other related information are trademarks of their respected companies or manufacturers. All items listed are identified as either new or used and the new may be older surplus. We list all items to the best of our ability and aim to provide the customer with as much information as possible. Ventureflorida is not liable for any products sold, the customer is responsible for proper testing, installation and use of equipment purchased. No warranties are expressed or implied.The sale of this item may be subject to regulation by the U.S. Food and Drug Administration and state and local regulatory agencies. If so, do not bid on this item unless you are an authorized purchaser. If the item is subject to FDA regulation, I will verify your status as an authorized purchaser of this item before shipping of the item. Domestic Shipping . We ship using UPS and FedEx to provide en-route package tracking. International Shipping We ship using UPS, FedEx and USPS. Items shipped by UPS and FedEx are more efficient and provide customers with en-route tracking. Items shipped by USPS cannot be tracked . International buyers are responsible for any and all applicable customs, duties, taxes and fees.