This is the bare PCB of a high power amplifier, based on TI's application note on the design and construction of BPA-200 amplifier. In this design, six pieces of LM3886T are used, in both parallel and BTL configuration. For 8 ohm load this amplifier can deliver up to 180Wrms of power and over 250Wrms for 4 ohm loading. The design uses opamp for DC servo to reduce the output DC to minimal and eliminates the use of trimmer potentiometers for DC adjustment. Each board contains one channel. For stereo application two boards are needed. The board contains SMT component. Appropriate soldering skill would be required during assembly. Board Dimension : 65mm x 218mm Board Thickness : 2mm Copper Thickness : 75uM ( 4 times normal thickness) Surface Finishing : Double sided solder-resist for maximum reliability. We provide schematic and part list to the buyers by email. We do air shipping worldwide at US$6.00. We welcome combine shipping. SquareTrade squaretrade warranty v2.0 Track Page Views With Auctiva's FREE Counter Powered by SoldEazy