Long Range Solar Powered Wireless Perimeter GSM Alarm System with 900 metre Transmission & 100 metre Detection, supplied with:
A Perimeter Alarm System to help you Monitor & Secure your Home & Business, ideal for DIY Installation (but can be expanded even more if required). Receiver: The Indoor 4 - Channel Wireless Receiver is powered by a standard 3-pin Plug in Transformer and has the following features:
Wireless Beams:
These impressive 2B Solar Powered Wireless Perimeter Beams (often called laser beams) are packed with impressive features listed below:
The Dual Detection Technology works by having a pair of Detectors (set 60 mm apart from each other) on each Beam, both Detectors have to be breached simultaneously to create an activation, allowing small animals, insects, leaves & debris to safely pass by. These 2B Beams have two pairs of these Dual Detectors which are located 260 mm apart from each other resulting in two invisible detection Beams set 260 mm apart. The External Beams are also supplied with an additional Charging Port which can be used to give the Beams a boost charge should you experience a lengthy duration of low sun light, or perhaps one of the beams needs to be fitted into a slightly covered location. It is also possible to add a separate Solar Panel onto any of the Beams if this helps with charging or positioning of the Beams. They are very easy to install as there is a Display Screen and Eye Sighting Lens. These Beams can be set to operate a small siren for a few seconds when activated (pressing ON/OFF button 3 - 6 times, or OFF by pressing the same ON/OFF button 7 or 8 times). You can use up to 128 sets of Beams with the Internal Receiver & 32 sets with the Solar Wireless Siren, you can mix & match by using a selection of different sizes of Beams within one single system.Operating Range:
The Wireless operating range between the Beams & Receivers is 900 metres (line of sight) which can be doubled by using the signal repeater (part number 004-29100.
KP9 GSM Auto-Dialler: The KP GSM Auto-Dialler is connected to the Wireless Receiver by a short length of bell cable (supplied) and communicates through mobile phone networks, a standard sized SIM Card needs to be fitted (not supplied but is available in the drop down above), you can use either PAYG or Contract. The Dialler operates on the mobile phone networks making it more reliable and is packed full of features normally only associated with much more expensive systems including:
The secret to using a GSM Auto-Dialler with a Perimeter Alarm is to use the Dialler as the brains of the system, therefore any additional External Sirens would be connected to the output of the Dialler (not the internal receiver), this gives you full control by using the:
The GSM Control Panel can also in different ways helping you a return on the investment, examples below:
You can add many additional accessories to this Perimeter Alarm system to suit your application including:
*You can use up to 128 sets of Wireless Detectors with this single Alarm System* If you require advice when building your system, please contact us for Friendly, No Obligation Advice !! Kit Includes:
Specification: Wireless Receiver Specification:
|